Alabama
Alaska
Arizona
Arkansas
California
Colorado
Connecticut
DC
Delaware
Florida
Georgia
Hawaii
Idaho
Illinois
Indiana
Iowa
Kansas
Kentucky
Louisiana
Maine
Maryland
Massachusetts
Michigan
Minnesota
Mississippi
Missouri
Montana
Nebraska
Nevada
New Hampshire
New Jersey
New Mexico
New York
North Carolina
North Dakota
Ohio
Oklahoma
Oregon
Pennsylvania
Rhode Island
South Carolina
South Dakota
Tennessee
Texas
Utah
Vermont
Virginia
Washington
West Virginia
Wisconsin
Wyoming
Flip the board so the bottom side faces upward and draw a semicircle at the unfinished end with a compass and pencil. This represents the cutline for a large notch/scallop that will facilitate scrapping the food from the board into a bowl.
Pass the board through the band saw and cut along the scallop tracing.
Add a drum sander to your drill press and smooth away any saw marks along the curved vertical edge of the scallop.
Install a rabbeting bit with ball bearing guides on your router. This bit will cut a recess into the bottom edge of the scallop while leaving a collar of wood on the top surface.
Turn the board bottom side up and route along the edge of the scallop to form the rabbet/recess. The recess will enable a bowl of a particular dimension to slide into the board without gaps and catch the food.
<< Previous Step Next Step >>
Home | Contact Us | Advertising & Product Placement | Media Inquiries | Privacy | Terms of Use | Pages Index
2009 Ron Hazelton Productions - Do It Yourself Home Improvement - All Rights Reserved
Website Design by Jonathan Preston and Mark Godwin
Page generated in 0.432 seconds