How to Build a Pullout for Pots and Pans - DIY Home Improvement Guides - How to Repair and Remodel your Bathroom, Kitchen and more

Local Guides

All Guides
Alabama
Alaska
Arizona
Arkansas
California
Colorado
Connecticut
DC
Delaware
Florida
Georgia
Hawaii
Idaho
Illinois
Indiana
Iowa
Kansas
Kentucky
Louisiana
Maine
Maryland
Massachusetts
Michigan
Minnesota
Mississippi
Missouri
Montana
Nebraska
Nevada
New Hampshire
New Jersey
New Mexico
New York
North Carolina
North Dakota
Ohio
Oklahoma
Oregon
Pennsylvania
Rhode Island
South Carolina
South Dakota
Tennessee
Texas
Utah
Vermont
Virginia
Washington
West Virginia
Wisconsin
Wyoming

Home Improvement > Kitchen > How to Build a Pullout for Pots and Pans

Learn how to build a pullout for pots and pans which maximizes storage agrea and eliminates the need to get down on the floor to access whatever is in the back.

Position and install the stationary half of four full extension drawer glides on the inside walls of the pullout case?two on each side. For the lower tray, lift each glide component off the bottom of the cabinet by placing a temporary strip of half-inch plywood underneath while you position and secure the glides with screws. Repeat this process without the plywood strip for the stationary portion of the glides for the upper tray. Measure carefully to position the glides accurately and allow room for both trays to operate properly when you assemble the pullout.
<< Previous Step Next Step >>