Alabama
Alaska
Arizona
Arkansas
California
Colorado
Connecticut
DC
Delaware
Florida
Georgia
Hawaii
Idaho
Illinois
Indiana
Iowa
Kansas
Kentucky
Louisiana
Maine
Maryland
Massachusetts
Michigan
Minnesota
Mississippi
Missouri
Montana
Nebraska
Nevada
New Hampshire
New Jersey
New Mexico
New York
North Carolina
North Dakota
Ohio
Oklahoma
Oregon
Pennsylvania
Rhode Island
South Carolina
South Dakota
Tennessee
Texas
Utah
Vermont
Virginia
Washington
West Virginia
Wisconsin
Wyoming
Before removing each section of wall board entirely, it's a good idea to cut an inspection hole. This way, you'll be able to check for problems, such as pipes or wires inside the wall.
To cut an inspection hole:
- Mark a square roughly in the middle of the section of wall board to be removed. This square should be large enough to reach your hand inside the wall so you can feel around for potential obstacles.
- Use a drywall saw to cut the square. When cutting, tilt the saw outward from the hole at a 45 degree angle. This will prevent the piece from falling inside the wall once you complete your cut. It will also allow you to use it as an easy patch if you find problems inside the wall.
Once you have cut the hole, reach inside the wall and feel around for wires and pipes. If you find simple electrical wiring (to an outlet, for instance), you may be able to move the outlet and wiring to another section of the wall so that it's not in the way.
Plumbing may present a more difficult challenge. If you find plumbing, you may want to consider using a different section of wall. Alternatively, you might consider using problematic wall sections for other purposes, like bulletin boards.
Repeat this process for each section of wall you plan to use.
<< Previous Step Next Step >>
Home | Contact Us | Advertising & Product Placement | Media Inquiries | Privacy | Terms of Use | Pages Index
2009 Ron Hazelton Productions - Do It Yourself Home Improvement - All Rights Reserved
Website Design by Jonathan Preston and Mark Godwin
Page generated in 0.555 seconds